Changing a kitchen sink tap can be daunting, but with the right tools and a little know-how, it can be a simple DIY project. This article will take you through the steps to change a kitchen sink tap. Click this link to buy kitchen mixer taps online.
Tools you’ll need:
- Adjustable wrench
- Basin wrench
- Screwdriver
- Plumbers tape
- New tap
Step 1: Turn off the water supply:
The first step is to turn off the water supply to your kitchen sink. You can turn off the valve under the sink. If you can’t find the valve, you may need to turn off the main water supply to your house.
Step 2: Remove the old tap:
Using an adjustable wrench, loosen and remove the nuts holding the old tap. You may need a basin wrench to reach the nuts in tight spaces. Once the nuts are removed, lift the old tap out of the sink.
Step 3: Clean the sink:
Before installing the new tap, clean the sink around the area where the old tap was located. This will ensure a tight seal when the new tap is installed.
Step 4: Install the new tap:
Place the gasket and mounting plate over the holes in the sink. Then, please insert the new tap into the holes and secure it with the nuts provided. Tighten the nuts with a basin wrench and adjust the tap to the desired position.
Step 5: Connect the water supply:
Wrap the threads of the new tap with plumbers’ tape to prevent leaks. Then, connect the water supply lines to the new tap. Use an adjustable wrench to tighten the connections.
Step 6: Test the new tap:
Once the water supply is connected, turn on the water and test the new tap. Check for any leaks around the base of the tap and the connections. If there are any leaks, tighten the connections until the leaks stop.
Changing a kitchen sink tap can be a simple DIY project with the right tools and know-how. Following these steps, you can change your kitchen sink tap and have it work like new. If you’re unsure about any steps or encounter problems, don’t hesitate to call a professional plumber for assistance.